T01-04 Hardware Detection - Huawei Tecal RH2485 V2 Operation Manual

Acceptance Manual
Tecal RH2485 V2 Server
T01-0303 Verifying the Backup Function
Objective
Test Networking
Diagram
Preset Conditions
Test Procedures
Expected Result
Test Description

T01-04 Hardware Detection

T01-0401 Verifying Hardware Detection
Objective
Test Networking
Diagram
Preset Conditions
Test Procedures
Expected Result
To verify whether the PSUs are configured in redundancy mode.
None
The structure of the mainboard, hard disk backplane, I/O board, indicator board, VGA
board, and power board is proper.
1. Install two PSUs in the server.
2. Connect power cables to the PSUs and wait 10 seconds till the server is
powered on, and the power status indicators are steady on.
3.
Remove the first PSU from the chassis.
Insert the first PSU into the slot. Check that the power status indicator is steady
4.
on.
5. Remove the second PSU from the chassis.
Insert the other PSU into the slot. Check that the power status indicator is
6.
steady on.
The server is working properly during the test, and no power failure occurs.
None
To verify that the system detects hardware properly
None
The structure of the mainboard, hard disk backplane, I/O board, indicator board, VGA
board, and power board is proper.
1. Power on the server. Press Del during the startup. Check that the BIOS SETUP
screen is displayed.
2. View the CPU model and quantity.
3. View the total memory capacity.
4. Choose Advanced > PXE Configuration, and view the media access control
(MAC) addresses of the four network ports.
5. View the system S/N.
6. View the basic input output system (BIOS) version.
1. The BIOS SETUP screen is displayed.
2. The CPU model and quantity are the same as the actual configurations.
3. The total memory capacity is compatible with actual configurations.
4. The MAC addresses of the four network ports are displayed.
5. The System S/N parameter is specified.
3
Part II Operation Guide