Huawei Tecal RH2485 V2 Operation Manual page 7

Acceptance Manual
Tecal RH2485 V2 Server
Test Procedures
Expected Result
Test Description
T02-0202 Verifying Basic iMana Functions
Objective
Test Networking
Diagram
Preset Conditions
Test Procedures
Expected Result
3. The Internet Explorer 8.0, Firefox 9.0, or later is available.
1. Power on the server system and wait about 10s.
2. Connect the terminal to the iMana management network port (connect to the
Mgnt port on the left of the VGA port), enter http://192.168.2.100, and press
Enter. Log in with the user name root and password Huawei12#$.
3. Choose System Information > Firmware Version, and view versions of the
firmware, such as, CPLD, iMana, BIOS, and FPGA.
4. Choose System Information > Asset Information, and view asset
information.
1. The firmware versions are properly displayed.
2. The values of Board Serial Number and Manufacture Date are properly
displayed.
None
To verify basic iMana functions
None
1. AC power is supplied to the server.
2. The default IP address of the iMana network port is 192.168.2.100/24.
3. The Internet Explorer 8.0, Firefox 9.0, or later is available.
1. Power on the server system and wait about 5 minutes until the BIOS setup
phase is complete.
2. Choose System Information > System Hardware, and view system hardware
information.
3. Choose Real-time Monitoring > Component, and view the temperature
monitoring information.
4. Choose Real-time Monitoring > Component, and view the power monitoring
information.
5. Choose Real-time Monitoring > Component, and view the fan speed
monitoring information.
6. Choose Real-time Monitoring > Component, and view the device status
monitoring information.
7. Perform other operations and estimate the network delay.
1. The hardware installation status and configurations are the same as actual site
information. The hardware includes the CPU, DIMM, hard disk, PSU, fan, hard
disk backplane, RAID controller card, NIC, integrated RAID card, and 10 GE
NIC.
2. The temperature status of the CPU and the air intake vent is shown as
3. The power reading is properly displayed, and the status is shown as
6
Part II Operation Guide
.
.