Table of Contents
Advertisement
iPATH Agility Controller
3. Installation
3.1 Connections
The iPATH Agility Controller unit is supplied fully pre-loaded and permits no local user interaction. All configuration takes place
remotely via the network connections and as a result only two connections are required: Network and power.
3.1.1 Network Connections
The iPATH Agility Controller has two network connections on the rear panel: port 1 on the left and port 2 on the right. These
allow the unit to be connected to internal and external network connections (respectively) as required. The external network
connection allows admin users located away from the internal network to be able to login. Network port 2 supports DHCP,
however, port 1 does not and needs to be configured manually.
1 Run a category 5, 5e or 6 link cable from the appropriate hub or router to the iPATH Agility Controller unit.
2 Connect the plug of the link cable to the left IP port (1) on the rear panel of the iPATH Agility Controller unit,
as shown in Figure 3-1:
Figure 3-1. Connecting Category 5, 5e or 6 cable from LAN / network switch.
724-746-5500 | blackbox.com
Page 16
Advertisement
Table of Contents
