The Receivers Tab; Search Filters; Receivers > View Receivers - Black Box ACR1000A-CTL-24 Manual

iPATH Agility Controller

4.6 The Receivers Tab

The Receivers tab shows a paginated table of all receiver devices within the iPATH Agility Controller network.
Click the RECEIVERS tab to view the initial View Receivers page.
The other Receivers pages (e.g. View Receiver Groups, Add Receiver Group, etc.) are selectable within the blue section located
just below the tabs.

4.6.1 Search Filters

The key fields (Name, Description and Location) all provide a search filter to locate particular items within long
lists. Enter a full or partial search string into the appropriate filter box and then click
Optionally use the buttons to invert the order of the listing.
The page will reload with the same pagination/sort order, but with the added search filter. It's possible to filter by several columns
at once (e.g. search for all entries with "mac" in the name, and "mixed" in the description). Search terms are case-insensitive. You
can re-sort and paginate on filtered results without losing the filters.
To remove a filter, click the red cross next to the relevant filter, (you can also empty the search box and click
4.6.2 Receivers > View Receivers
The table shows the following information for each receiver:
• Name
• IP address
• Description & Location
The Manage icons are as follows:
(Note: You can hover your mouse pointer over any icons to reveal additional information)
Configure device: Displays the "Configure Receiver" page.
Reboot device: Allows you to reboot or reset a unit to its factory settings. A popup will ask which task you wish to carry
out. A reboot is useful if a device enters an unknown state. A reset will return the unit to its factory default state and reset
its IP address (the unit will retain any firmware updates that have been applied).
Identify unit: Causes the LED lights to flash on the front of the selected unit. An alert will be shown if the unit cannot be
contacted (e.g. if it is offline)
Delete device: This brings up two options: Delete the device which removes it from the list, or Replace, where it can be
replaced with new hardware of the same type. The Replace option is useful if you have faulty hardware that needs
swapping. This means that you do not have to configure the new hardware as it will have same settings as the previous
Agility.
Connect to a channel: A list of available channels is shown, along with connection modes (view/shared/exclusive). The
admin user can thus remotely change channel on any receiver.
Disconnect: If a receiver is currently connected to a channel, clicking the disconnect icon will end the connection,
regardless of who is connected. Hovering over the icon will show which user is connected, which channel they are
connected to, and when the connection was created.
Page 42
• Online status
• Firmware revision of receiver unit
• Manage (admin options - see below)
724-746-5500 | blackbox.com
to start the search.
again).