Table of Contents
Advertisement
CHAPTER 3: INSTALLATION
3.1 CONNECTIONS
The iPATH server unit is supplied fully pre-loaded and permits no local user interaction. All configuration takes place remotely via
the network connections and as a result only two connections are required: Network and power.
Note: If an existing iPATH server must be replaced, follow the important advice given within
server).
Note: The iPATH server is supplied with the front panel USB connections blanked off. There is no need to connect a keyboard or
mouse to the unit as configuration takes place across the network connection.
3.1.1 NETWORK CONNECTIONS
The iPATH server has two network connections on the rear panel: port 1 on the left and port 2 on the right. These allow the unit
to be connected to internal and external network connections (respectively) as required. The external network connection allows
admin users located away from the internal network to be able to login. Network port 2 supports DHCP, however, port 1 does not
and needs to be configured manually.
TO CONNECT THE INTERNAL IP NETWORK PORT
1 Run a category 5e or 6 link cable from the appropriate hub or router to the iPATH server unit.
2 Connect the plug of the link cable to the left IP port (1) on the rear panel of the iPATH server unit.
Category 5e or 6 cable from
LAN / network switch
Note: The precise operation of the two ports are determined within the iPATH server Management Suite, particularly the
Dashboard > Settings > Network
12
page.
1.877.877.2269
Appendix C (Swapping out an iPATH
BLACKBOX.COM
NEED HELP?
LEAVE THE TECH TO US
LIVE 24/7
TECHNICAL
SUPPORT
1.877.877.2269
Advertisement
Table of Contents
