Black Box ACR1000A-CTL-24 Manual page 31

Chapter 4: Configuration
4.4.2.5 Dashboard > Settings > Network
This page applies global network parameters to the iPATH Agility Controller network.
Syslog Enabled
Determines whether Syslog should be used to record log data to an external Syslog server.
Syslog IP Address
The address of the external syslog server.
Require SSL for Web
If set to yes, a certificate needs to be downloaded and all connections will then take place using HTTPs:// connections rather than
the default HTTP:// connection types.
Multicast IP Address
The start address for the multicast IP addresses to be used. Multicast IP addresses are in the range 237.1.1.1 to 239.255.255.255.
This setting lets you adjust this range of IP Multicast addresses. It is important to allow sufficient addresses for your system. For
instance, if the multicast IP address base was set to 239.255.255.252 there would only be 4 multicast addresses available.
IP Address Pool
To make it easier to add new devices to the network you can now specify an IP address pool that can be used. By stating the
lower and upper IP addresses, all those in between will be auto assigned to the Agility devices when they are acquired by iPATH
Agility Controller.
Ethernet Port 1
The IP address settings for the primary iPATH Agility Controller Ethernet port, which can only be configured on a static IP address.
Ethernet Port 2
The IP settings for Ethernet port 2 can be disabled, configured on a static IP address or DHCP used to set the IP address, as
required.
SNMP
This option allows the iPATH Agility Controller to connect to an external SNMP server. If SNMP is enabled, there are three
connection modes:
• Authentication + privacy
• Authentication only
• No authentication
There are two authentication types SHA or MD5 and two Privacy types AES or DES.
The MIB file can be downloaded from http://<IP>/iPATH-MIB.txt
724-746-5500 | blackbox.com
Page 31