Table of Contents
Advertisement
4.6.4 Receivers > Add Receiver Group or Configure Group
From the View Receiver Groups page, you can create a new group or configure an existing group:
• To create a new group: Click the "Add Receiver Group" option.
• To configure an existing group: Click
The Add and Configure pages are similar in content.
Login Required
• No: When selected, anyone can use a receiver terminal and connect to a channel. The channels/permissions displayed to this
anonymous user are those that are set for the "anonymous user" defined within the Dashboard > Settings page.
• Inherit from global setting: When selected, the requirement for user login will be determined by the "Login Required"
setting within the Dashboard > Settings page.
• Yes: When selected, a user will need to login with the username and password defined in the "Users" section. They will only
be allowed to login if they have been granted permission to access devices in the receiver group.
Enable Receiver OSD Alerts
Determine the required setting for pop up OSD alerts: Inherit, No or Yes.
The next fields are the USB settings.
Note: USB port reservation and advanced USB features will be added to future releases of the iPATH Agility Controller
management system.
Enable Video Compatibility Check
This reads the EDID from the attached monitor and determines whether the monitor is capable of displaying the selected video
mode before connecting a channel. This prevents the receiver showing a black screen and the user being locked out because a
dual link resolution has been selected to display on a single link monitor.
Force 60Hz
If enabled, the receiver frame rate is held at 60Hz regardless of the video input frame rate. The Video Switching options (below)
cannot be altered when this option is enabled.
Video switching
Provides two options for video switching:
• Fast Switching (default state) - Retains the same frame rate (at either 50Hz or 60Hz) depending upon which video resolution
was displayed first.
• Match Frame Rate - Follows the source frame rate and will change the frame rate every time this changes even if the video
resolution doesn't change. If you have one receiver switching between 1920x1080@60Hz and 1920x1080@50Hz then this
setting will change the frame rate from 60Hz to 50 Hz every time that you switch.
USB Settings
See next page.
for a group.
724-746-5500 | blackbox.com
Chapter 4: Configuration
Page 45
Advertisement
Table of Contents
