Table of Contents
Advertisement
2. Remove the (2) screws and washers inside the frame (part numbers 77G0599 and 1625437).
3. Remove the (3) screws at the top of the frame (part number 54G2882). The use of a stepladder is
recommended for this procedure.
4. With all the screws removed, rock the cover to the right from the top. There are features built into the
cover that lock it behind the left cover, and these features must be clear before you can lift the cover
from the frame. To make lifting the cover easier, tilt the top of the cover away from the frame after the
feature tabs have cleared the left cover.
5. Use steps 2 and 3 to remove the the left side cover.
6. With all the screws removed from the cover, tilt the top of the cover away from the frame and lift off.
Removing the Rack Top Frame for Clearance Through Doorways
The following steps describe removal of the rack top frame for clearance through doorways.
1. Use the jack screws to stabilize and lift the rack off the floor, as follows:
a. Loosen the jam nut on each leveling foot by turning the nut counterclockwise.
b. Rotate each leveling foot downward until it contacts the surface on which the rack is placed.
c. Adjust the leveling feet downward as needed until the rack is level. When the rack is level, tighten
the jam nuts against the base by turning the nut clockwise.
1 Jam Nut
2 Leveling Foot
1
2
3
3 Rack Base
Appendix J. Removing and Installing the Rack Top Frame
161
Advertisement
Table of Contents
