Table of Contents
Advertisement
Step 9. Connect and Route the Power Cords to the pSeries 670
Before you connect the power cords, loosen or remove the cable retainers and filler plate located along
the side and bottom of the frame.
The following lists each of the brackets and recommended range of cable sizes for each:
Part Number
Description
07H6823
Cable Retention Bracket
07H6824
Cable Retention Bracket
11P1262
Cable Retention Bracket
07H6764
Filler Plate (thin)
07H6763
Filler Plate (wide)
31L7174
Soft Cable Ties (roll)
The pSeries 670 has two power cords, one in the rear and one in the front. To route the front power cord,
do the following:
1. Connect the plug to the Bulk Power Assembly (BPA), and ensure that the dots are aligned on the plug
and receptacle.
2. Secure the power cord in the channel, with the brackets from top to bottom.
3. Loosen the screw on the brackets in the track on the left side. Remove the UEPO switch, and route
the power cord behind the UEPO switch.
4. Remove the lower panel or tool box from the frame, and route the cord through the channel under the
frame.
Quantity
2
12
4
3
4
1
1 Tool Box Cover
2 Tool Box and Lower Panel (Some of the lower panels may not have a tool
box)
Recommended Usage
Use in the base of the frame to retain cables
leaving the frame. This bracket is used for
large diameter cables.
Use in the base of the frame to retain the
cables leaving the frame. This bracket is used
for medium diameter cables.
Use in the base of frame to retain the cables
leaving the frame. This bracket is used for
small diameter cables and fiber.
Use in the base of the frame to cover the
openings. Install in the base of the frame after
all of the cable retention brackets are installed.
Use in the base of the frame to cover
openings. Install in the base of the frame after
all of the cable retention brackets are installed.
Use to organize the cables leaving frame.
Chapter 2. Installing the pSeries 670
15
Advertisement
Table of Contents
