Table of Contents
Advertisement
17. Install the UEPO switch, as follows:
a. Install the top and bottom screws. Screws should be bottomed against the end of the slot prior to
tightening.
b. Plug in the cables.
Replacing Covers
Refer to page "Removing the Covers" on page 160 while performing this task.
1. Examine the bottom of the frame side for two "U" brackets installed at the bottom. These correspond
to open slots in the bottom of the covers.
2. Always install the left side cover first.
3. Lift the cover and engage the slot into the "U" bracket, holding the cover at approximately a 30-degree
angle, with the top away from the frame.
4. Install the top three screws (part number 54G2882). Use a stepladder for this procedure. Push against
the top of the cover to compress the gasket to allow alignment with the tapped holes in the top of the
frame.
5. Install the two inside screws and washers (part numbers 77G0599 and 1625437).
6. Install the right side cover into the "U" bracket, while holding it an angle away from the frame.
7. Because the right side cover has tab features that engage behind the left side cover, the cover must
be rocked to the right from the top to clear the left side cover. After clearing the cover with the tabs,
push the cover against the frame while rocking it back to the left. The cover should rest on the "U"
bracket. The top flange should rest on the frame, and the tabs should be positioned behind the left
cover.
Note: The covers should be flush in the middle with a small gap between them.
8. Repeat steps 4 and 5 to complete the installation of the right side cover.
174
Eserver pSeries 670 Installation Guide
Advertisement
Table of Contents
