Table of Contents
Advertisement
Hardware Management Console for pSeries (HMC) to the Primary I/O
Book
To connect your HMC to the pSeries 670, connect the serial cable into serial port 1 located on the back of
the HMC. Connect the other end of the serial cable into the HMC1 connector located on the primary I/O
book in the managed system. The following illustration shows the location of the serial ports on the back of
the HMC and the HMC connectors located on the processor subsystem.
1 Primary Rack
2 Primary I/O Book
3 Power Plug to External Power Source (wall
plug)
150
Eserver pSeries 670 Installation Guide
4 Primary HMC Connected to HMC #1 in Primary
I/O Book (HMC #1 may be labeled HSC #1)
5 Optional Second HMC Connected to HMC #2
in Primary I/O Book (HMC #2 may be labeled
HSC #2)
Advertisement
Table of Contents
