Hantek 1008 User Manual page 21

Hantek1008
■
Input a signal to a channel of the oscilloscope
The oscilloscope is equipped with eight channels.
Please input signal in the following steps:
1. Set the attenuation switch on the probe as 10X and connect the probe on the osci-
lloscope with CH1. Aim the slot in the probe connector at the faucet on BNC of CH1
and insert, then, turn right to lock the probe. Finally, attach the tip of probe and ground
nip to the Connector of Probe compensator.
2. Set the CH1 probe attenuation of the oscilloscope to X10. (The default is X1).