Hantek 1008 User Manual page 26

4. It shows the main time base setting.
5. The Horizontal Panel
The user can change Time/DIV, format in the panel.
6. The Vertical Panel
The user can turn on/off the CH1/.../CH8. Also the user can change the CH1/
.../CH8 volt/div, coupling and probe attenuation.
7. The Trigger Panel
In this panel, the user can change the trigger mode, sweep, source and slope.
8. It shows the system time.
9. Marker shows edge trigger level.
10. It shows the CH1-CH8 information
Readouts show the coupling of the channels.
Readouts show the vertical scale factors of the channels.
A "B" icon indicates that the channel is bandwidth limited.
11. The software status indicates it connected via USB.
12. The markers show the reference points of the displayed waveforms. If there is
no marker, the channel is not displayed.
13. A window that shows the display waveform in buffer position.
14. Marker shows horizontal trigger position.
15. Trigger status indicates the following:
AUTO: The oscilloscope is in auto mode and is acquiring waveforms even no triggers
have been found.
Trig'D: The oscilloscope has found a trigger and is acquiring the post trigger data.
WAIT: All pretrigger data has been acquired and the oscilloscope is ready to accept
a trigger.
STOP: The oscilloscope has stopped acquiring waveform data.
RUN: The oscilloscope is running.
PLAY: The oscilloscope is displaying the record waveforms.
8
Hantek 1008
DIGITAL OSCILLOSCOPE