Resetting The Boot Lun Setting In H700 Bios After Running Rm; Docs\~Final_Dr4000_1.0.1.1_Docs\~Final_1.0.1.1_Dr4000_Admin_Guide_Files - Dell DR4000 Administrator's Manual

FILE LOCATION: C:\Users\bruce_wylie\Documents\~Dell

Docs\~FINAL_DR4000_1.0.1.1_DOCS\~Final_1.0.1.1_DR4000_Admin_Guide_Files\~3-

3 During the time when the Power-On Self-Test (POST) screen displays,
press F11 to load the Boot Manager.
4 Within the Boot Manager, navigate to and select the USB key as the boot
device, and press Enter.
5 After a few minutes, Restore Manager loads and displays its main screen.
6 Select the desired Restore mode (Recover Appliance or Factory Reset).
7 Enter the confirmation string, and press Enter to proceed.
CAUTION:
The Factory Reset mode deletes all DR4000 data. The Factory Reset
mode should only be used when the container data is no longer needed.
NOTE:
After Restore Manager completes, only the administrator account will
remain enabled. To re-enable the root or service accounts, see the user --enable
--user CLI commands in the
NOTE:
If you had previously joined the DR4000 system to any Active Directory
Services (ADS) domain before running Restore Manager, after it completes you will
need to manually rejoin the desired ADS domain. For information about joining an
ADS domain, see "Configuring Active Directory Settings" on page 39.

Resetting the Boot LUN Setting in H700 BIOS After Running RM

In the event that both of the 2.5-inch 300 GB 10K RPM 6 GB/s SAS internal
drives (OS) in RAID1 are replaced, you need to run Restore Manager to
recover the DR4000 system OS drives.
Following the RM recovery process, the boot logical unit number (LUN) has
to be reset to VD0 RAID1. The DR4000 system unsuccessfully attempts to
boot from RAID6 instead of RAID1.
To resolve this issue, you must reset the H700 BIOS to revise the proper boot
order setting to configure the proper boot LUN to be RAID1. To reset the
proper LUN boot order, complete the following steps:
1 Start Restore Manager and select Option 1  Recover My Appliance.
The OS Virtual Disk will be created: Warning Code 2002 dialog is
displayed.
D E L L C O N F I D E N T I A L – P R E L I M I N A R Y 4 / 5 / 1 2 - F O R P R O O F O N LY
80
Using the DR4000 System Support Options
Dell DR4000 System Command Line Reference Guide
.