Dell DR4000 Administrator's Manual page 111

FILE LOCATION: C:\Users\bruce_wylie\Documents\~Dell
Docs\~FINAL_DR4000_1.0.1.1_DOCS\~Final_1.0.1.1_DR4000_Admin_Guide_Files\~3-
Table 8-2. DR4000 System Event Messages
System Event Message
System Event = Type 1
NVRAM is not yet ready to accept
write commands.
NVRAM hardware has failed.
File server is failing repeatedly.
DR4000 system is entering
Maintenance mode so it can run the
filesystem scan utility.
DR4000 system is not initialized.
NVRAM does not match the data
volume.
DR4000 software upgrade is in
progress.
DR4000 software upgrade did not
complete.
DR4000 software upgrade
completed successfully.
DR4000 software upgrade
completed successfully.
The filesystem server has been
restarted in read-only mode.
The filesystem server has been
started in read-only mode.
D E L L C O N F I D E N T I A L – P R E L I M I N A R Y 4 / 5 / 1 2 - F O R P R O O F O N LY
Description/Meaning or Action
Contact Dell Support for support assistance or
intervention. Wait until the NVRAM is ready.
Contact Dell Support for support assistance or
intervention.
Contact Dell Support for support assistance or
intervention. For more information, see "About
the DR4000 Maintenance Mode" on page 118.
Contact Dell Support for support assistance or
intervention. For more information, see
"Initializing the DR4000 System" on page 13.
If this is a newly replaced NVRAM, use
maintenance --hardware --reinit_nvram
commands to reinitialize the NVRAM. For
more information, see the
Command Line Reference Guide
Informational message. No user intervention is
required.
Retry the DR4000 software upgrade. For more
information, see "About the Software Upgrade
Page and Options" on page 76.
A DR4000 system reboot is required. For more
information, see "Rebooting the DR4000
System" on page 38.
Informational message. No user intervention is
required.
Informational message. No user intervention is
required.
Informational message. No user intervention is
required.
Troubleshooting and Maintenance
Dell DR4000 System
.
103