Oracle Database Appliance X6-2-HA Owner's Manual page 85

Install the Oracle Database Appliance X3-2/X4-2 DE2-24P Storage Shelf Into a Rack
a. Use the T20 Torx driver to remove the rail location pegs from the front
and rear of the rails [1].
b. Use a 10mm wrench (supplied) to insert the pins into the ends of the
rails where you removed the location pegs [1].
c. Position the front of the rails inside the cabinet, with the rail flange
inside of the cabinet flange, and the rail label facing the inside of the
cabinet [2].
The pins should be fully located within the rack holes.
d. Insert and loosely tighten one screw through the front of the rack and
into the top hole in the rails [3].
The screws for threaded racks have an unthreaded area near the top of the shaft.
Before threading these screws into the rails, thread them through the rack until the
threads clear the rack and the screws turn freely.
Chapter 4 • Installing the System Into a Rack 85