ABB RES670 2.1 Commissioning Manual page 187

1MRK 511 366-UUS -
Commissioning manual
Table 16: Self-supervision signals on the local HMI
HMI Signal Name: Status
INT Fail OFF / ON
INT Warning OFF / ON
ADMnn READY / FAIL
BIMnn READY / FAIL
BOMn READY / FAIL
IOMn READY / FAIL
MIMn READY / FAIL
RTC READY / FAIL
Time Sync READY / FAIL
Application READY / FAIL
RTE READY / FAIL
IEC61850 READY / FAIL
LMD READY / FAIL
LDCMxxx READY / FAIL
OEM READY / FAIL
Description
This signal will be active if one or more of
the following internal signals are active;
INT--LMDERROR, INT--WATCHDOG,
INT--APPERROR, INT--RTEERROR, or
any of the HW dependent signals
This signal will be active if one or more of
the following internal signals are active;
INT--RTCERROR, INT--
IEC61850ERROR, INT--
TIMESYNCHERROR
Analog input module n failed. Signal
activation will reset the IED
BIM error. Binary input module Error
status. Signal activation will reset the IED
BOM error. Binary output module Error
status.
IOM-error. Input/Output Module Error
status.
mA input module MIM1 failed. Signal
activation will reset the IED
This signal will be active when there is a
hardware error with the real time clock.
This signal will be active when the source
of the time synchronization is lost, or when
the time system has to make a time reset.
This signal will be active if one or more of
the application threads are not in the state
that Runtime Engine expects. The states
can be CREATED, INITIALIZED,
RUNNING, etc.
This signal will be active if the Runtime
Engine failed to do some actions with the
application threads. The actions can be
loading of settings or parameters for
components, changing of setting groups,
loading or unloading of application
threads.
This signal will be active if the IEC61850
stack did not succeed in some actions like
reading IEC61850 configuration, startup
etc.
LON network interface, MIP/DPS, is in an
unrecoverable error state.
Line Differential Communication Error
status
Optical Ethernet Module error status.
Section 13
Troubleshooting
181