Fnc 11 - Zcp / Zone Compare - Mitsubishi Electric MELSEC FX3U Programming Manual

FX /FX /FX Series Programmable Controllers
3G 3U 3UC
Programming Manual - Basic & Applied Instruction Edition
9.2 FNC 11 – ZCP / Zone Compare
Outline
This instruction compares two values (zone) with the comparison source, and outputs the result (smaller,
equal or larger) to bit devices (3 points).
1. Instruction format
FNC 11
D ZCP
2. Set data
Operand Type
S
1
S
2
S
D
3. Applicable devices
Bit Devices
Oper-
and System User
Type
X Y M T C S D .b KnX KnY KnM KnS T C D R U \G
S
1
S
2
S
D
1: "D .b" is available only in FX
2: This function is supported only in FX
256
Mnemonic
16-bit Instruction
P
ZCP
9 steps
ZCPP
Data or device number handled as lower comparison value
Data or device number handled as upper comparison value
Data or device number handled as comparison source
Head bit device number to which comparison result is output
Digit Specification
1
and FX
3U
→ For the contact comparison instruction, refer to Chapter 28.
→ For floating point comparison, refer to Section 18.2.
Operation Condition
32-bit Instruction
Continuous
Operation
Pulse (Single)
Operation
Description
Word Devices
Special
System User
Unit
2
2
2
PLCs. However, index modifiers (V and Z) are not available.
3UC
/FX PLCs.
3U 3UC
9 Move and Compare – FNC 10 to FNC 19
9.2 FNC 11 – ZCP / Zone Compare
Mnemonic Operation Condition
DZCP
17 steps
DZCPP
16- or 32-bit binary
16- or 32-bit binary
16- or 32-bit binary
Others
Con- Real
Index
stant Number
V Z Modify K H E
Continuous
Operation
Pulse (Single)
Operation
Data Type
Bit
Charac-
Pointer
ter String
" " P