FX
/FX
/FX
Series Programmable Controllers
3G
3U
3UC
Programming Manual - Basic & Applied Instruction Edition
Appendix A-1-3 Precautions on Use of (Built-in USB) Programming Port
Make sure to set the contents described in this section when executing circuit monitor, device registration
monitor, program reading/writing, etc. in the FX
Developer Ver. 8.72A or later. For GX Developer prior to Ver. 8.72A, communication using the (built-in USB)
programming port is not available.
1. Installation of USB driver (GX Developer Ver. 8.72A or later)
It is necessary to install the USB driver to execute USB communication using the (built-in USB) programming
port.
For the USB driver installation method and procedure, refer to the following manual.
2. Setting in GX Developer (Ver. 8.72A or later)
1) Select [Online]
2) Double-click [Serial] in [PC side I/F] to open "PC side I/F Serial setting" dialog box.
3) Select "USB (Built-in port)".
A display screen is the example of Ver.8.72A.
4) Click [OK] button to finish the setting.
→
[Transfer setup...] to open "Transfer setup" dialog box.
Double-click it.
A Programming Tool Applicability and Version Upgrade History
PLC using the (built-in USB) programming port and GX
3G
→ GX Developer Operating Manual (Startup)
Select "USB (Built-in port)"
A-1 Programming Tool Applicability
953
31
32
33
34
35
36
37
38
A
B