Step 3 - Connect Power; Alternate Power-Supply Connections - Rabbit RCM3365 User Manual

2.2.3 Step 3 — Connect Power
When all other connections have been made, you can connect power to the Prototyping
Board. Connect the wall transformer to jack J1 on the Prototyping Board as shown in
Figure 3.
Plug in the wall transformer.
RCM3365/RCM3375 and the Prototyping Board are now ready to be used.
NOTE: A RESET button is provided on the Prototyping Board to allow a hardware reset
without disconnecting power. The RCM3365/RCM3375 can also be reset from
Dynamic C by pressing <Ctrl-Y> if your PC is connected to the RCM3365/RCM3375
via the serial programming cable.

2.2.3.1 Alternate Power-Supply Connections

All Development Kits include a header connector that may be used to connect your power
supply to 3-pin header J2 on the Prototyping Board. The connector may be attached either
way as long as it is not offset to one side—the center pin of J2 is always connected to the
positive terminal, and either edge pin is negative. The power supply should deliver 8 V to
30 V DC at 8 W.
User's Manual
The core LED on the Prototyping Board should light up
. The
13