Rabbitweb Sample Programs; Where Do I Go From Here - Rabbit RCM3365 User Manual

—This program demonstrates ICMP by pinging a remote host. It will flash
•
PINGLED.C
LEDs DS3 and DS4 on the Prototyping Board when a ping is sent and received.
—This program demonstrates using the SMTP library to send an e-mail when
•
SMTP.C
the S2 and S3 switches on the Prototyping Board are pressed. LEDs DS3 and DS4 on
the Prototyping Board will light up when e-mail is being sent.

6.6.1 RabbitWeb Sample Programs

You will need to have the Dynamic C RabbitWeb module installed before you run the
sample programs described in this section. The following sample programs are in the
Dynamic C
SAMPLES\RCM3360\TCPIP\RABBITWEB
—This program demonstrates a basic example to change the rate at
•
BLINKLEDS.C
which the DS3 and DS4 LEDs on the Prototyping Board blink.
•
DOORMONITOR.C
in to the Prototyping Board when using this sample program. This program demon-
strates adding and monitoring passwords entered via the LCD/keypad module.
—This program demonstrates how to schedule times for the relay and
•
SPRINKLER.C
digital outputs in a 24-hour period.

6.7 Where Do I Go From Here?

NOTE: If you purchased your RCM3365/RCM3375 through a distributor or through a
Rabbit partner, contact the distributor or partner first for technical support.
If the sample programs ran fine, you are now ready to go on.
Additional sample programs are described in the Dynamic C TCP/IP User's Manual.
Please refer to the Dynamic C TCP/IP User's Manual to develop your own applications.
An Introduction to TCP/IP provides background information on TCP/IP, and is available
on the CD and on our
User's Manual
—The optional LCD/keypad module (see Appendix C) must be plugged
Web site.
folder.
65