Connect Power; Overseas Development Kits - Rabbit RabbitCore User Manual

C-programmable core module with ethernet, serial flash

Table of Contents

2.2.3 Connect Power

When all other connections have been made, you can connect power to the Prototyping

Board. Connect the wall transformer to 3-pin header J4 on the Prototyping Board as

shown in Figure 3. The connector may be attached either way as long as it is not offset to

one side.

Plug in the wall transformer. The LED above the

button on the Prototyping Board

RESET

should light up. The RCM3750 and the Prototyping Board are now ready to be used.

NOTE: A RESET button is provided on the Prototyping Board to allow a hardware reset

without disconnecting power.

Development kits sold outside North America include a header connector that may be

connected to 3-pin header J4 on the Prototyping Board. The connector may be attached

either way as long as it is not offset to one side. The red and black wires from the connec-

tor can then be connected to the positive and negative connections on your power supply.

The power supply should deliver 7.5 V–30 V DC at 5 W.

RabbitCore RCM3750

Table of Contents

Do you have a question about the RabbitCore and is the answer not in the manual?

Rcm3750