Load Tcp/Ip Parameters To The Rcm3365 Module - Rabbit RCM3365 User Manual

E.1 Load TCP/IP Parameters to the RCM3365 Module
1. Connect the 10-pin
the RCM3365 module as described in Section 2.2.2. (Do not use the
2. Use the File menu to open the sample program
the Dynamic C
SAMPLES\RABBITSYS
run the program.
This sample program brings down the Ethernet interface, turns off DHCP, sets the
RCM3365's IP address to 10.10.6.100, sets the netmask to 255.255.255.0, and sets the
default gateway to 10.10.6.1.
The IP and gateway addresses can be changed in the two macros in the two macros at the
beginning of the sample program:
#define _IPADDR"10.10.6.100"
#define _GATEWAY"10.10.6.1"
To restore the RCM3365 to its default DHCP behavior, uncomment the
macro:
//#define ENABLE_DHCP
138
PROG connector of the serial programming cable to header J1 on
folder. Press function key
The RCM3365 module is now set up.
SETUPFORCROSSOVER.C
F9
RabbitCore RCM3365/RCM3375
connector.)
DIAG
, which is in
to compile and
ENABLE_DHCP