Table of Contents
Advertisement
Distributor of Digi International: Excellent Integrated System Limited
Datasheet of 101-0453 - MODULE RABBITCORE RCM2300
Contact us: sales@integrated-circuit.com Website: www.integrated-circuit.com
2.3.3 Connect Power Supply
When the above connections have been made, you can connect power to the RabbitCore
Prototyping Board.
Hook the connector from the wall transformer to header J5 on the Prototyping Board as
shown in Figure 6. The connector may be attached either way as long as it is not offset to
one side.
R39
D3
RT1
C3
PROG
Plug in the wall transformer. The power LED (DS1) on the Prototyping Board should light
up. The RCM2300 and the Prototyping Board are now ready to be used.
NOTE: A RESET button is provided on the Prototyping Board to allow hardware reset
without disconnecting power.
To power down the Prototyping Board, unplug the power connector from J5. You should
disconnect power before making any circuit adjustments in the prototyping area, changing
any connections to the board, or removing the RCM2300 from the board.
Getting Started Manual
AC Adapter
RCM2300
C23
C11 U1
C8
R15
JP2
JP1
DIAG
Figure 6. Power Supply Connections
Prototyping
Board
Reset
Switch
11
Advertisement
Table of Contents
