Standalone Operation Of The Rcm3365/Rcm3375 - Rabbit RCM3365 User Manual

C-programmable core module with nand flash mass storage and ethernet

Table of Contents

A program "runs" in either mode, but can only be downloaded and debugged when the

RCM3365/RCM3375 is in the Program Mode.

Refer to the

Rabbit 3000 Microprocessor User's Manual

gramming port.

4.3.2 Standalone Operation of the RCM3365/RCM3375

The RCM3365/RCM3375 must be programmed via the Prototyping Board or via a similar

arrangement on a customer-supplied board. Once the RCM3365/RCM3375 has been pro-

grammed successfully, remove the serial programming cable from the programming con-

nector and reset the RCM3365/RCM3375. The RCM3365/RCM3375 may be reset by

cycling the power off/on or by pressing the

RCM3365/RCM3375 module may now be removed from the Prototyping Board for end-

use installation.

CAUTION: Disconnect power to the Prototyping Board or other boards when removing

or installing your RCM3365/RCM3375 module to protect against inadvertent shorts

across the pins or damage to the RCM3365/RCM3375 if the pins are not plugged in

correctly. Do not reapply power until you have verified that the RCM3365/RCM3375

module is plugged in correctly.

User's Manual

for more information on the pro-

button on the Prototyping Board. The

RESET

Table of Contents

Rcm3375