Rabbit RCM3365 User Manual page 75

It is recommended that you allow for an "exclusion zone" of 0.04" (1 mm) around the
RCM3365/RCM3375 in all directions when the RCM3365/RCM3375 is incorporated into
an assembly that includes other printed circuit boards. An "exclusion zone" of 0.08"
(2 mm) is recommended below the RCM3365/RCM3375 when the RCM3365/RCM3375
is plugged into another assembly. Figure A-2 shows this "exclusion zone."
Figure A-2. RCM3365/RCM3375 "Exclusion Zone"
NOTE: All measurements are in inches followed by millimeters enclosed in parentheses.
User's Manual
2.81
(71.2)
2.725
(69.2)
1.93
(49.0)
J4
1.850
(47.0)
J3
69