Set Individual Attribute Times; Time For Cue-Lists In Chase Mode; Snap Percentage - Code MINI 1000 User Manual

6.5.2. Set Individual Attribute Times

The attributes times have only delay in and fade in times. Users can switch to other
attributes by pressing attribute keys.
After set the attribute times, those attributes will not use global times unless you press
[Use Global] again.
Press [Use Global] if you want the selecting attribute times resume to global times.

Press [Attribute Time Use Global] if you want all attribute times resume to global

times.

6.5.3. Time for Cue-lists in Chase mode

The global times and attribute times are unavailable for the cue-lists in chase mode.
Times for chase mode can only be set by wheel D, while the cross set by key Shift with
wheel D.
Cross=100% means steps will use the time to fade in next step.

Cross=0% means steps will not have fade in time. The time is

used as delay in for each step.
Speed=1.0s means every step in the chase runs in 1.0 second.

6.5.4. Snap Percentage

[Snap Percent] allows users to control when the instant channels should be occurred. It
defaults in 0%.
If snap percent is 0% the channel occurs at the beginning of the cue fade in.
If snap percent is 100% the channel occurs at the end of the cue.
If snap percent is 50% the channel occurs in the middle of the cue.
MINI_1000_en.pdf
34
http://www.codelight.com