Getting Started; Switching On And Setting Up - Pioneer RCS-LX60D Operating Instructions Manual

03

Getting started

Chapter 3
Getting started

Switching on and setting up

When you switch the recorder on for the first time, you
can make several basic settings using the Setup
Navigator feature. This takes you through setting the
clock, the internal TV tuner and the video output.
If you're using the recorder for the first time, we strongly
recommend you use the Setup Navigator before starting
to use the recorder.
1 Switch on your TV and set the video input to this
recorder.
RECORDER
2 Switch on the recorder.
When you switch on for the first time, your TV should
display the Setup Navigator screen (If the Setup
Navigator doesn't appear, you can also access it from the
Initial Setup menu; see page 137).
• If this recorder is connected to a compatible TV using
a fully-wired 21-pin SCART cable, the recorder will
take a few seconds to download country, TV screen
size and language information. (Check the manual
that came with your TV for compatibility information.)
ENTER
3 Choose a language (then press ENTER).
Initial Setup
Basic
Basic
Tuner
Video In/ O ut
Audio In
Audio O ut
Language
Re cording
Playback
Note
1 If the recorder does not accept the On or Auto setting (the highlight jumps back to Off), check that the antenna is properly connected and
that it is not shorted, then try making the setting again.
56
En
Clock Setting Language
Input Line System
Pow er Save
HELPp
Setup N avig ator Setup N avig ator
4 Start the Setup Navigator.
ENTER
k Setting
Complete this setup before you
t Line System
start using your recorder.
er Save
Start Start
P
Cancel
p Navigator p Navigator
Please use the Initial Setup if you
want to make more detailed settings.
• If you don't want to use the Setup Navigator, press
to select Cancel, then press ENTER to exit the Setup
Navigator.
ENTER
5 Select an Aerial Power setting
built-in digital tuner.
• On: power is always supplied to the connected aerial,
whether the recorder is on or in standby.
• Auto: power is only supplied when this recorder is on.
• Off: power is never supplied to the aerial.
ENTER
6 Select 'Auto Scan' to start scanning for
D.TV channels.
• Select Do not set if you want to skip D.TV channel
setup (because they have already been set up, for
example), then skip to step 8 below.
ENTER
7 Select your country.
The recorder starts scanning for new channels. After the
scan is complete the recorder will let you know how many
new channels were found.
• The country setting will apply to both the digital and
analog TV tuners.
• The clock will also be set automatically here if D.TV
channels are found.
• If no new channels were found a message appears
asking if you want to scan again. Check the aerial
connection before selecting Yes. (If you select No,
skip to step 8 below.)
1
for the