Pioneer RCS-LX60D Operating Instructions Manual page 144

15 The Initial Setup menu
Setting
D.TV Age Limit
This setting is only applicable when the country is set to France, Denmark, Finland or Sweden.
HDMI Output
(only available when an HDMI device is connected)
Screen Resolution
• If you choose a setting that is incompatible with your TV you may not be able to see any picture at all. In this case, press
holding down the
setting).
• If you have the Colour set to YCbCr 4:2:2, you cannot select 720 x 576i (720 x 480i).
4:3 Video Output
Colour
• Depending on the connected device some settings may not be available.
• When a DVI device is connected, the YCbCr 4:2:2 and YCbCr 4:4:4 options are not available.
• You cannot choose YCbCr 4:2:2 when the Screen Resolution is set to 720 x 576i (720 x 480i).
Audio Output
This setting is not available when a DVI device is connected
Options
On Screen Display
Front Panel Display
144
En
Options
Next Screen
1920 x 1080p
1920 x 1080i
1280 x 720p
720 x 576p
(720 x 480p)
720 x 576i
(720 x 480i)
(Stop) button on the front panel to switch the setting (this also switches Component Video Out on page 139 to the default
Full
Normal
RGB (0–255)
RGB (16–235)
YCbCr 4:2:2
YCbCr 4:4:4
Auto •
PCM
Bitstream Priority
On •
Off
On •
Off
Explanation
Use this screen to enter an age limit for D.TV programmes. Programmes
that are broadcast with age suitability guidelines that fall above the age set
here will require the correct password to be entered before the channel can
be viewed.
You must also enter your password in order to change the age limit setting.
Constant 1920 x 1080p output.
Constant 1920 x 1080i output.
Constant 1280 x 720p output.
Constant 720 x 576p output (when setting the Input Line System to
525 System, video is output in 720 x 480p).
Constant 720 x 576i output (when setting the Input Line System to
525 System, video is output in 720 x 480i).
Select if your HDMI TV allows you to change the aspect ratio.
Select if your HDMI TV does not allow you to change the aspect ratio. 4:3
video will be shown with bars on each side.
Use if colours are weak and black appears to 'float' on the RGB (16–235)
setting.
Use this setting if colours appear overly rich and the black too deep on the
RGB (0–255) setting.
The video signal is output as a 10-bit YCbCr 4:2:2 component signal. This is
the standard setting for HDMI-compatible devices.
The video signal is output as a 8-bit YCbCr 4:4:4 component signal.
Dolby Digital, MPEG and DTS sources are output as a bitstream signal.
However, depending on the Audio Out setting, number of audio channels,
and the HDMI-connected device, Linear PCM audio may be output.
All audio signals are converted to Linear PCM (except DTS).
Select if the connected device is compatible with bitstream audio.
.
The recorder displays operation displays (Stop, Play, etc.) on-screen.
Switches off the on-screen operation displays.
The time is shown in the front panel display when the recorder is in standby.
The front panel display is switched off in standby.
OPEN/CLOSE while