Pioneer RCS-LX60D Operating Instructions Manual page 12

02 Connecting up
Receiver subwoofer (SX-LX60D)
6
SYSTEM CONNECTOR
USE ONLY WITH DISPLAY UNIT.
SEE INSTRUCTION MANUAL.
8
5 Connect each speaker.
• The front and surround speaker cables have a color-
coded connector at one end and two bare wires at the
other end.
• Since there is only one terminal to connect the two
center speakers, you will need to use the supplied Y-
cable for the connection.
• Twist and pull off the protective shields on each wire.
• Connect the wires to the speaker. Each speaker in the
illustration can be identified by means of the color-
coded indicator provided on the rear-surface model
label. Match the color-coded wire with the color
indicator on the model label, then insert the color-
coded wire into the red (+) side and the other wire
into the black (–) side.
12
En
ANTENNA
FM UNBAL 75 AM LOOP ANTENNA
MCACC
AUDIO INPUT
SETUP MIC CONTROL IN
DIGITAL
SPEAKERS DVD/DVR1 DVD/DVR2 DIGITAL ANALOG
CONTROL
(COAXIAL) (OPTICAL) (OPTICAL)
OUT SUBWOOFER R SURROUND L
5
L
R
R L
CENTER FRONT
AC IN
To AC outlet
Color-coded wire
(Connect to speaker)
Color-coded connector
(Connect to rear panel)
Surround right
(Gray)
Center
Listening position
(Green)
Y-cable
Front right
(Red)
Speaker system (SSP-LX60D)
• When connecting the center speakers, connect the Y-
cable dual end to the two center speakers in the
same way.
• Connect the other end to the color-coded speaker
terminals on the rear of the receiver subwoofer. Make
sure to insert completely.
The small lug at the wire-end of the speaker plug
should face up or down depending on whether it's
being plugged into one of the upper or lower speaker
terminals. Please make sure to connect correctly.
Upper terminal
Surround left
(Blue)
Center
(Green)
Front left
(White)
Y-cable
To Receiver subwoofer
Lower terminal