Pioneer RCS-LX60D Operating Instructions Manual page 60

03 Getting started
4 If you are using an external receiver (such as a
satellite receiver) with the supplied G-LINK cable,
complete this step, otherwise jump to step 5 below.
• See Connecting to a cable box or satellite receiver on
page 51 for more on using the supplied G-LINK cable.
• Select External Receiver 1, 2 or 3, then press
ENTER. (If you have just one external receiver, use
External Receiver 1. You can add further receivers in
2 and 3 if you need to.)
After pressing ENTER:
• Select your reception method (Terrestrial, Cable or
Satellite).
• Select your provider (if applicable).
• Select the brand of your external receiver.
• Identify which input your external receiver is
connected to.
After completing these steps the recorder will try and
communicate with your external receiver and change the
channel via the G-LINK cable. If the channel was
successfully changed, select Yes to confirm.
If the channel did not change, select No. The GUIDE
Plus+ system will try other codes assigned to your
external receiver. If none of the codes changes the
channel successfully, tune your external receiver to the
host channel for your country (refer to step 5 below) and
leave it on overnight. The recorder needs to be in standby;
it will wake up automatically and download new codes
from the host channel. The next day, try this setup
process again:
• Press GUIDE to display the GUIDE Plus+ screen.
• Press to highlight the Menu bar, then use
reach the Setup area and select Setup.
• Continue setting up from the start of this step again.
If your external receiver still doesn't respond to the G-
LINK controller, please call customer support and report
the brand and model of your external receiver.
See also GUIDE Plus+ FAQ and troubleshooting on
page 71.
60
En
5 Identify the host channel for your country.
The TV listings information available in the GUIDE Plus+
system is distributed throughout Europe by selected
broadcasters called host channels. It is important that
the host (analog) channel for your country is correctly
identified in order to receive listings information (EPG
download).
Follow A, B or C below depending on your setup:
A If you are not using an external receiver, this
recorder will automatically scan all channels for the
host channel:
• Leave the recorder in standby overnight (do not leave
it switched on).
B If you are using an external receiver, you need to
identify the host channel from the table below:
Country/
Host channels Comments
Region
Austria Eurosport
Belgium RTL-TVI
France Canal+
Germany Eurosport
Italy MTV
Netherlands Eurosport
Spain Tele 5
Switzerland Eurosport
UK ITV, Eurosport
• Tune your external receiver to the appropriate host
channel and leave the receiver on and the recorder in
standby overnight.
C If you use both an external receiver and this
recorder as sources, follow the instructions above for
setting up without an external receiver. Only if this is
unsuccessful try the external receiver method.
About EPG download
• EPG data can only be received when the recorder is
in standby. (When not using the recorder, therefore,
please switch it into standby.) If you're using an
external receiver, leave this on when EPG data is
to
downloading.
• If you cannot receive any of the host channels (see
the above table) then you won't be able to use the
GUIDE Plus+ system. In this case do not set the
postal code (or set Country to Other) in the GUIDE
Plus+ setup screen. (When GUIDE Plus+ service
starts in your area, set the postal code again.)
Analog only
Analog only
Analog only
ITV is analog only. Use Eurosport
if you are a SKY subscriber and
you no longer have an analog
terrestrial antenna.