Pioneer RCS-LX60D Operating Instructions Manual page 157

Additional information
Message
• The HDD has not been sufficiently
optimized. Please optimize again.
• An error occurred. Please consult the service
center. Note that contents on the HDD may be
erased when servicing this unit.
• The Hard Disk Drive info is incorrect. Use the
Disc Setup menu to reinitialize.
• This signal's TV system is different from the
recorder's setting.
• Recording failed due to a TV system
mismatch. Press DISPLAY to clear message.
• Playback has stopped because the TV system
is different than the recording.
• You are not allowed to watch this
Conditional Access Programme.
• There is no DV input or the input signal is
unrecordable.
• No DV camcorder connected.
• You cannot connect more than one DV
camcorder at a time.
• Cannot operate the DV camcorder.
• Could not operate the DV camcorder.
• The DV camcorder is not set for playback.
Please select playback mode on the DV
camcorder.
• The printer is not ready or is not connected.
Please check the printer.
• Printing has been cancelled because ...
Explanation/Action
If this message appears repeatedly after optimizing the HDD it is
likely that there is not enough free space on the HDD for
optimization to complete properly. Please erase some titles from the
HDD and optimize again.
This message is displayed when information from the HDD cannot
be read. The HDD may be damaged or broken. Please ask your
nearest Pioneer-authorized service center or your dealer to carry out
repairs.
As the HDD info cannot be properly read, no new recordings can be
made. Reinitializing the HDD (page 133) may result in your being
able to make recording again. Note that reinitializing the HDD will
erase all recorded contents, including protected files.
The TV system (PAL, NTSC, etc.) of the current channel is different
from the TV system settings of this recorder.
The timer recording failed because the TV system of the channel set
for recording was different from the setting of the recorder.
During recording or timer recording standby, the TV System (PAL,
NTSC, etc.) of the playback video changed, causing playback to stop
automatically.
A CA module or smart card (obtained from your service provider) is
required to watch the selected programme. Insert the supplied
module or card into the Common Interface card slot on the front
panel of the recorder (page 17).
No signal was detected at the DV IN jack. This may appear if a blank
section of DV tape is playing in the connected camcorder.
The camcorder is not connected properly, or the camcorder is
switched off.
This recorder's DV jack supports connection to just one camcorder.
This recorder cannot operate the DV camcorder. Try switching off the
camcorder then turn it back on again.
This recorder was not able to operate the DV camcorder.
The camcorder is in camera mode. Switch it to playback mode.
This message is displayed when communication could not be
established with the printer. See the Troubleshooting section if you
do not know the cause.
This message is displayed when there is a printer error during
printing. After checking the printer for the cause of the error, either
reconnect the printer and start the printing job again, or select "Yes"
to resume printing (select "No" to cancel the print job). See also the
operating instructions that came with your printer for possible
causes of print errors.
16
157
En