Pioneer RCS-LX60D Operating Instructions Manual page 25

Getting started
1 Connect the microphone to the MCACC SETUP
MIC jack on the rear panel.
MCACC
SETUP MIC
ANTENNA
FM UNBAL 75
MCACC
AUDIO INPUT
SETUP MIC CONTROL IN
DIGITAL
SPEAKERS DVD/DVR1 DVD/DVR2
SYSTEM CONNECTOR CONTROL
(COAXIAL) (OPTICAL)
OUT R L
SUBWOOFER SURROUND
USE ONLY WITH DISPLAY UNIT.
SEE INSTRUCTION MANUAL.
R L
CENTER FRONT
AC IN
2 Place the microphone at your normal listening
position.
Place it about ear height, and make sure it is level by
using a table or chair.
Make sure there are no obstacles between the speakers
and the microphone.
3 If the receiver subwoofer is off, press
to turn the power on.
4 Press MCACC.
Try to be as quiet as possible after pressing MCACC. The
volume increases automatically and the system outputs
a series of test tones.
• To cancel Auto MCACC setup before it has finished,
press MCACC. The unit will continue to use the
previous settings.
• If the ambient noise level is too high, NOISY blinks in
the display for five seconds. To exit and check the
1
noise levels , press MCACC, or to try again, press
ENTER when RETRY shows in the display.
• If you see an ERR MIC or ERR SP message in the
display, there may be a problem with your mic or the
speaker connections. To try again, press ENTER
2
when you see RETRY .
When the MCACC setup is complete, the volume level
returns to normal, COMPLETE
Acoustic Calibration EQ is activated.
Note
1 • If the room environment is not optimal for the Auto MCACC setup (too much ambient noise, echo off the walls, obstacles blocking the speak-
ers from the microphone) the final settings may be incorrect. Check for household appliances (air conditioner, fridge, fan, etc.), that may be
affecting the environment and switch them off if necessary.
• Some older TVs may interfere with the operation of the mic. If this seems to be happening, switch off the TV during Auto MCACC setup.
2 If this doesn't work, press MCACC, turn off the power, and check the problem indicated by the ERR message, then try the Auto MCACC setup
again.
3 If COMPLETE doesn't appear, it is likely an error occurred during the setup. Please check all connections and try again.
4 See Listening with Acoustic Calibration EQ on page 28 to switch on/off Acoustic Calibration EQ.
AM LOOP ANTENNA
DIGITAL ANALOG
(OPTICAL)
L
R
RECEIVER
3
shows in the display, and
4
05
25
En