Pioneer RCS-LX60D Operating Instructions Manual page 136

14 The Video Adjust menu
3 Select the picture quality setting you want to
adjust.
Memory1
Prog. Motion
PureCinma
YNR
BNR
MNR
Sharpness
Detail
You can adjust the following settings:
• Prog. Motion – Adjusts the motion and still picture
quality when video output is set to progressive. (Prog.
Motion is ineffective when PureCinema is On.)
• PureCinema – This setting optimizes the picture for
film material when the video output is set to
progressive. Usually set to Auto 1 but try switching
to Auto 2, On or Off if the picture appears unnatural.
• YNR – Adjusts the amount of noise reduction (NR)
applied to the Y (brightness) component.
• BNR – Adjusts the amount of noise reduction (NR)
applied to the block noise (artefacts visible in areas of
flat colour, caused by MPEG compression).
• MNR – Adjusts the amount of noise reduction (NR)
applied to the mosquito noise (artefacts visible
around the edges of an image, caused by MPEG
compression).
• Sharpness – Adjusts the sharpness of the high-
frequency (detailed) elements in the picture.
Sharpness is ineffective for HDMI output.
• Detail – Adjusts how sharp edges appear.
• White Level – Adjusts the intensity of white. White
Level is ineffective for HDMI output.
• Black Level – Adjusts the intensity of black. Black
Level is ineffective for HDMI output.
• Black Setup – Corrects the standard reference black
level. Black Setup is ineffective for HDMI output.
• Gamma Correction – Adjusts the brightness of
darker images. Gamma Correction is ineffective for
HDMI output.
• Hue – Adjusts overall balance between red and
green. Hue is ineffective for HDMI output.
• Chroma Level – Adjusts how rich the colours
appear. Chroma Level is ineffective for HDMI output.
4 Use the
selected picture quality setting.
5 When you have all the settings as you want
them, press HOME MENU to exit.
136
En
Motion Still
Auto1
Off Max
Max
Off
Off Max
Fine
Soft
Soft Fine
buttons to adjust the currently
Tip
• To see more of the picture as you adjust different
settings, press ENTER after selecting the setting you
want to adjust.