Configuring Fips; Overview; Fips Self-Tests; Power-Up Self-Test - HP 12500 Series Configuration Manual

Configuring FIPS

Overview

The Federal Information Processing Standard (FIPS) 140-2, developed by the National Institute of
Standard and Technology (NIST) of the United States, specifies the security requirements for
cryptographic modules. FIPS 140-2 defines four levels of security, simply named "Level 1" to "Level 4"
from low to high. The device supports Level 2.
Unless otherwise noted, FIPS in the document refers to FIPS 140-2.

FIPS self-tests

When the device works in FIPS mode, it has self-test mechanisms, including the power-up self-test and
conditional self-tests, to ensure the normal operation of cryptography modules. You can also trigger a
self-test. If a self-test fails, the device restarts.

Power-up self-test

The power-up self-test, also called "known-answer test", examines the availability of FIPS-allowed
cryptographic algorithms. A cryptographic algorithm is run on data for which the correct output is
already known. The calculated output is compared with the known answer. If they are not identical, the
known-answer test fails.
The power-up self-test examines the following cryptographic algorithms: DSA (signature and
authentication), RSA (signature and authentication), RSA (encryption and decryption), AES, 3DES, SHA1,
SHA256, SHA512, HMAC-SHA1, and random number generator algorithms.

Conditional self-tests

A conditional self-test runs when an asymmetrical cryptographic module or a random number generator
module is invoked. Conditional self-tests include the following types:
Pair-wise consistency test—This test is run when a DSA/RSA asymmetrical key-pair is generated. It
•
uses the public key to encrypt a plain text, and uses the private key to decrypt the encrypted text. If
the decryption is successful, the test succeeds. Otherwise, the test fails.
• Continuous random number generator test—This test is run when a random number is generated.
If two consecutive random numbers are different, the test succeeds. Otherwise, the test fails. This test
is also run when a DSA/RSA asymmetrical key pair is generated.

Triggered self-test

To examine whether the cryptography modules operate normally, you can use a command to trigger a
self-test on the cryptographic algorithms. The triggered self-test is the same as the power-up self-test.
319