HP 12500 Series Configuration Manual page 146

Configuration considerations
Configure the portal server and enable portal server heartbeat function and the portal user
1.
heartbeat function.
Configure the RADIUS server to implement authentication.
2.
Configure cross-subnet portal authentication on interface VLAN-interface 4 of the switch.
3.
Configure the portal server detection function on the switch, so that the switch can detect the status
4.
of the portal server by cooperating with the portal server heartbeat function.
Configure the portal user information synchronization function, so that the switch can synchronize
5.
portal user information with the portal server by cooperating with the portal user heartbeat
function.
Configuration prerequisites
Configure IP addresses for the host, switch, and servers as shown in
•
can reach each other.
Configure the RADIUS server properly to provide authentication for users.
•
• If the portal server is an IMC server, the RADIUS server must be an IMC server, too.
Configuring the portal server (IMC PLAT 5.1 SP1)
This example assumes that the portal server runs on IMC PLAT 5.1 SP1 (E0202P05) and IMC UAM 5.1
SP1 (E0301P03).
Configure the portal server:
1.
Log in to IMC and select the Service tab.
a.
Select Portal Service Management > Server from the navigation tree to enter the portal server
b.
configuration page, as shown in
Configure the portal server heartbeat interval and user heartbeat interval.
c.
Use default values for other parameters.
d.
Click OK.
e.
Figure 51.
136
Figure 50 and make sure they