HP 12500 Series Configuration Manual page 332

Validating file. Please wait..........................
Saved the current configuration to mainboard device successfully.
Configuration is saved to device successfully.
[Sysname] quit
# Reboot the switch.
<Sysname> reboot
CAUTION:
After you enable the FIPS mode, be sure to create a local user and its password before you reboot the
switch. Otherwise, you cannot log in to the switch. To log into the switch, you must reboot the switch
without loading the configuration file (by ignoring or removing the configuration file).
Verify the configuration:
2.
After the switch reboots, enter the username test and password AAbbcc1234%. The system prompts that
your first login is successful, and asks you to enter a new password. Enter a new password which has at
least four characters different than the previous one and confirm the password. Then, the system displays
the <Sysname> prompt.
User interface aux0 is available.
Please press ENTER.
Login authentication
Username:test
Password:
Info: First logged in. For security reasons you will need to change your password.
Please enter your new password.
Password:**********
Confirm :**********
Updating user(s) information, please wait...........
<Sysname>
# Display the current FIPS mode. You can see that the FIPS mode is enabled.
<Sysname> display fips status
FIPS mode is enabled
322