HP 12500 Series Configuration Manual page 47

Task
Displaying and maintaining HWTACACS
Creating an HWTACACS scheme
The HWTACACS protocol is configured on a per scheme basis. Before performing other HWTACACS
configurations, follow these steps to create an HWTACACS scheme and enter HWTACACS scheme
view:
Step
1. Enter system view.
2. Create an HWTACACS scheme
and enter HWTACACS scheme
view.
NOTE:
Up to 16 HWTACACS schemes can be configured.
•
• A scheme can be deleted only when it is not referenced.
Specifying the HWTACACS authentication servers
You can specify one primary authentication server and up to one secondary authentication server for an
HWTACACS scheme so that the NAS can find a server for user authentication when using the scheme.
When the primary server is not available, the secondary server is used. In a scenario where redundancy
is not required, specify only the primary server.
To specify HWTACACS authentication servers for an HWTACACS scheme:
Step
1. Enter system view.
2. Enter HWTACACS
scheme view.
3. Specify HWTACACS
authentication servers.
Command
system-view
hwtacacs scheme
hwtacacs-scheme-name
Command
system-view
hwtacacs scheme hwtacacs-scheme-name
•
Specify the primary HWTACACS
authentication server:
primary authentication ip-address
[ port-number | vpn-instance
vpn-instance-name ] *
•
Specify the secondary HWTACACS
authentication server:
secondary authentication ip-address
[ port-number | vpn-instance
vpn-instance-name ] *
37
Remarks
Optional.
Remarks
N/A
Not defined by default.
Remarks
N/A
N/A
Configure at least one
command.
No authentication server is
specified by default.