HP 12500 Series Configuration Manual page 65

Select Device Management Service as the service type.
c.
Select HP(General) as the access device type.
d.
Select the access device from the device list or manually add the device with the IP address
e.
10.1.1.2.
Click OK.
f.
NOTE:
The IP address of the access device specified here must be the same as the source IP address of the RADIUS
packets sent from the device, which is chosen in this order:
The IP address specified with the nas-ip command on the device
•
The IP address specified with the radius nas-ip command on the device
•
• The IP address of the outbound interface (the default)
Figure 13 Adding an access device
# Add a user for device management.
From the navigation tree, click the User tab, and select Access User View > Device Mgmt User.
Then, click Add to configure a device management user as follows:
Add a user named hello@bbb and specify the password.
a.
Select SSH as the service type.
b.
Set the EXEC privilege level to 3. This value identifies the privilege level of the SSH user after
c.
login, which is 0 by default.
Specify the IP address range of the hosts to be managed as 10.1.1.0 to 10.1.1.255.
d.
Click OK.
e.
55