Remote Software Download/Activation Using The Gne - Cisco ONS 15454 Reference Manual

Chapter 2 Procedures and Provisioning
If the APPLY command is successful, logout of the TL1 session using the CANC-USER command:
Step 2
Example 2-45 CANC-USER::CISCO15:1;
After a successful completion of the APPLY command the NE will reboot and the TL1 session will
disconnect. When the NE comes up after the reboot it will be running the new software. Traffic switches
are possible during activation.

2.6.6 Remote Software Download/Activation Using the GNE

In a network with SDCC-connected ONS 15454, ONS 15327 and ONS 15310-CLs remote download and
activation are possible using the GNE/ENE feature supported in TL1. The GNE must be connected by a
LAN and the remaining ENEs can download the new software package through fiber from the GNE.
For remote software downloading, complete the steps in the
page 2-45
command is filled with the ENE node name.
Each GNE can support 20 (TCC2/TCC2P) or 6 (XTC or 15310-CL-CTX) concurrent communication
gateway sessions and up to a maximum of 176 (TCC2/TCC2P) or 96 (XTC or 15310-CL-CTX)
ENEs/GNE. For more information on TL1 Gateway, see the
Example 2-46 ACT-USER:NODE1:CISCO15:1;
Five simultaneous software downloads can be initiated using the COPY-RFILE command with
appropriate TIDs. All downloads will be independent of each other and download speeds might differ.
Example 2-47 COPY-RFILE:NODE1:RFILE-PKG:CTAG::TYPE=SWDL,SRC="FTP://TL1:
Individual REPT EVT FXFR messages can be isolated using the node names. RTRV-NE-GEN also
requires the individual node names entered in the TID to see a specific download status.
You can activate the software on all of the nodes using the GNE node.
Note Activate the GNE last, after activating all the ENEs or else ENE connectivity will be lost when the GNE
starts to reboot for activation.
VA454-94 1970-01-07 01:18:18
M 1 COMPLD
;
and the "Activate New Software" procedure on page
ACT-USER:NODE2:CISCO15:1;
ACT-USER:NODE3:CISCO15:1;
ACT-USER:NODE4:CISCO15:1;
ACT-USER:NODE5:CISCO15:1;
CISCO454@10.77.29.199/USR/CET/VINTARA/15454-0340-X02E-2804.PKG";
COPY-RFILE:NODE2:RFILE-PKG...
COPY-RFILE:NODE3:RFILE-PKG...
COPY-RFILE:NODE4:RFILE-PKG...
COPY-RFILE:NODE5:RFILE-PKG...
2.6.6 Remote Software Download/Activation Using the GNE
"Download New Software" procedure on
2-48, but ensure that the TID in each
"2.3 TL1 Gateway" section on page
Cisco ONS SONET TL1 Command Guide, R6.0
2-25.
2-49