Monef; Splte - Cisco ONS 15454 Reference Manual

Chapter 2 Procedures and Provisioning
Figure 2-10
(2 times the bandwidth
of the circuit accessed)
The MONE and SPLTA modes are applicable to unidirectional circuits from E to F. The MONF and
Note
SPLTB modes are applicable to unidirectional circuits from F to E.

2.2.9.3 MONEF

Monitor EF (MONEF) is a monitor connection provided from the FAD1 (odd pair) to a DFAD, to the A
transmission path and from FAD2 (even pair) of the same DFAD, to the B transmission path of the
accessed circuit. This is a non-intrusive mode
MONEF for T3 (DS3 HCDS) indicates that the odd pair of a FAP is providing a monitor connection to
the A transmission path and from the even pair of a facility access path (FAP) to the B transmission path
of the accessed circuit.
Figure 2-11
(2 times the bandwidth
of the circuit accessed)

2.2.9.4 SPLTE

Split E (SPLTE) splits both the A and B paths and connects the E side of the accessed circuit to the FAD
(Figure 2-12
QRS is not supported on the ONS 15454, ONS 15327, and ONS 15310-CL. The connection will remain
Note
as is. The ONS 15600 inserts AIS instead of QRS.
MONF Access Dual TAP
E
A
AID
B
Dual-FAD TAP
MONEF Access Dual TAP
E
A
AID
B
Dual-FAD TAP
and Figure 2-13).
F
"Mapped"
AID
(Figure 2-11).
F
"Mapped"
AID
Cisco ONS SONET TL1 Command Guide, R6.0
2.2.9 Test Access Mode Definitions
2-17