2.12.19 Overhead Circuit Provisioning Rules
2.12.19 Overhead Circuit Provisioning Rules
1.
2.
3.
4.
5.
6.
2.12.20 Hardware Limitation Rules
1.
2.
3.
Cisco ONS SONET TL1 Command Guide, R6.0
2-80
LOW/EOW is possible between the AIC-I, OCn and TXP/TXPP cards in any combination in
line-terminated mode.
F1/D4-D12 UDC:
a.
Not possible between TXP/TXPP and AIC-I cards in line-terminated mode.
b.
Not possible between TXP/TXPP and OCn cards in line-terminated mode.
Possible between OC-N ports.
c.
All OH bytes are passed across client and DWDM ports in transparent mode.
SDCC/LDCC tunneling is not possible in line-terminated mode.
No end-to-end OH circuit provisioning. In Release 6.0 you can stitch them at each node.
For MXP_MR_2.5G and MXPP_MR_2.5G cards these rules apply to the trunk port only.
ESCON SFP does not support any monitoring.
Optics thresholds and PM are not shown on client ports.
HI/LO-TXPOWER is not supported for TXP_MR_2.5G and TXPP_MR_2.5G Cards.
Chapter 2
Procedures and Provisioning