Rept Dbchg; Montype Defined For Ethernet Statistics And Condition Type For Tca; Enumerated Types; Tmper - Cisco ONS 15454 Reference Manual

2.10.10 REPT DBCHG

2.10.10 REPT DBCHG
Reports any changes on the NE that result from issuing the following commands:
1.
2.
Also reports when an RMON PM schedule is created or deleted via the SCHED-PMREPT-<MO2>
command.

2.10.11 MONTYPE Defined for Ethernet Statistics and Condition Type for TCA

The names of Ethernet and Fibre Channel montypes are defined exactly as they are defined in the
corresponding SNMP MIB statistics group. For example, etherStatsUndersizePkts will be used as the
name for the same RMON statistics defined in request for comment (RFC)1757.
Unlike the PM of other SONET entities (such as, STS path, OCn), there are two condition types defined
for the TCAs of each RMON-managed statistics type; Ethernet or Fibre Channel montype. One
condition type is for the rising threshold, and the other is for the falling threshold. For example, there
are two condition types for etherStatsUndersizePkts stats type: T-etherStatsUndersizePkts-HT for the
rising threshold, and T-etherStatsUndersizePkts-LT for the falling threshold.
For platform-specific PM information, refer to the Procedure Guide and Reference Manual of that
Note
platform.

2.10.12 Enumerated types

2.10.12.1 TMPER

Table 2-15
Values
1-DAY
15-MIN
1-MIN
Cisco ONS SONET TL1 Command Guide, R6.0
2-66
ENT-RMONTH-<MOD2>
DLT-RMONTH-<MOD2>
TMPER Type
Description
Performance Parameter Accumulation Interval Length - Every 24 Hours.
For SONET PM data (line/session/path), only 1 day of history data is
available.
For RMON managed data stats, there are 7 days of history data are
available.
Performance Parameter Accumulation Interval Length - Every 15 Minutes.
32 history data are available.
Performance Parameter Accumulation Interval Length - Every 1 minute.
Only applicable to RMON stats.
60 history data are available.
Chapter 2 Procedures and Provisioning