Figure 2-4 Multinode View (Mone Example) - Cisco ONS 15454 Reference Manual

2.2.8 Test Access Configurations
Example 2-13 ED-STS1::STS-1-1:90:::TACC=1:;
This command changes STS1 and STS2 on Slot 1 to a TAP. The <CTAG> is 90. Sets the TAP number
to 1.
Example 2-14 CONN-TACC-STS1::<AID for E or F depending on MD>:91::TAP-1:MONE
This command connects the <AID> to the TACC defined by TAP 1 on the E side. <CTAG> is 91.
The connection made in the CONN-TACC command can use MONE to connect to the F side <AID>.
Note
The <AID> provided designates the E side and the other automatically becomes the F side. For example,
if an <AID F> is supplied to a MONE connection the top line would be connected to the side of the path,
or what is shown in the diagram as the F side. When a CONN-TACC is set up, these designations cannot
change until a DISC-TACC or another CONN-TACC command is issued. The connection is based on the
<AID> supplied.
In the
Note
FADs (28 VTs).
Figure 2-4
NE1
NE2
On NE3:
Example 2-15 ENT-CRS-STS1::<AID I-G>:100::2WAY;
On NE1:
Assuming the path from A to B is already entered; the A and B points in the diagram refer to entry and
exit points on the node or different cards. The E/F designators refer to the two 2-way connections from
NE3.
Cisco ONS SONET TL1 Command Guide, R6.0
2-14
Figure 2-3 configuration there might be a single DS-3 port wired-up but configured as 14 dual
Multinode View (MONE Example)
A
E
OC12
F
B
OC12
C
D
ENT-CRS-STS1::<AID J-H>:101::2WAY;
G
I
H
NE3
J
A connection, not a TAP . CTAG is 100.
Second connection, not a TAP .
Chapter 2 Procedures and Provisioning
RTU