Typical Application Diagram; Led Diagnostics - Altronix AL400ULACM Installation Manual

Fig. 1
Access Control Panel
C
Output
NO
Relay
NC
F1
LED1
Mag.
Lock
NC C NO COM NC C NO COM
OUTPUT 1
Electric
Strike
Electromagnetic
Door Holders
Power Supply Board
LED
Red (DC) Green (AC)
ON ON
ON OFF
OFF ON
OFF OFF
Red (Bat) Battery Status
ON Normal operating condition.
OFF Battery fail/low battery.
ACM8 Access Power Controller
LED ON
LED 1 - LED 8 (Red) Output relay(s) energized.
Trg (Green) FACP input triggered (alarm condition).
ACM series

Typical Application Diagram:

Normally Open (N.O.)
Door Releasing
Device
Keypad
IN GND IN GND IN GND IN GND IN GND IN GND
1 2 3 4 5
F2
F3 F4 F5
LED2 LED3 LED4 LED5
NC C NO COM NC C NO COM NC C NO COM
OUTPUT 2 OUTPUT 3 OUTPUT 4
UL Listed
Power Supply
For this application
corresponding
fuse F8 must be
removed.

LED Diagnostics:

Power Supply Status
Normal operating condition.
Loss of AC. Stand-by battery supplying power.
No DC output. Short circuit or thermal overload condition.
No DC output.
Available from A1 Security Cameras
www.a1securitycameras.com email:sales@a1securitycameras.com
Fig. 1a
Intact = Dry Input
Cut = Wet Input
TRG
TRG
IN GND IN GND
6 7 8
F6 F7 F8
O N O N
1 2 3 4
LED6 LED7 LED8
J3
NC C NO COM NC C NO COM NC C NO COM
OUTPUT 5 OUTPUT 6 OUTPUT 7 OUTPUT 8
MAG.
LOCK
J3
Intact = DC Input
Cut = AC Input
NC C NO COM
OUTPUT 8
OFF
Output relay(s) de-energized.
FACP normal (non-alarm condition).
FACP
(Fire Alarm
Control
Panel)
FACP Dry
Form "C" Output
SW1-SW8
1 2 3 4
FACP Interface
Disabled
MAIN
10A 250V
Enabled
J2 J1
AC or DC AC or DC
Power Power
Supply Supply
(req'd.) (optional)
Fig. 1d
Intact = One P/S Input
Cut = Dual P/S Input
J2 J1
Fig. 1b
Fig. 1c
- 5 ­