Altronix ACM8E Installation Manual

Altronix ACM8E Installation Manual

Access power controller
Hide thumbs Also See for ACM8E:

Advertisement

Quick Links

ACM8E and ACM8CBE
Access Power Controllers
Installation Guide
Models Include:
ACM8E
- Eight (8) Fuse Protected Outputs
ACM8CBE
- Eight (8) PTC Protected Outputs
Altronix Corp.
140 58th St. Brooklyn, NY
More than just power.
TM
Rev. 092503

Advertisement

Table of Contents
loading

Summary of Contents for Altronix ACM8E

  • Page 1 ACM8E and ACM8CBE Access Power Controllers Installation Guide Models Include: ACM8E - Eight (8) Fuse Protected Outputs ACM8CBE - Eight (8) PTC Protected Outputs Altronix Corp. 140 58th St. Brooklyn, NY More than just power. Rev. 092503...
  • Page 2: Specifications

    These units convert one (1) 12 to 24 volt AC or DC input into eight (8) independently controlled fused or PTC protected outputs. These power outputs can be converted to dry form “C” contacts (ACM8E only). Outputs are activated by an open collector sink or normally open (NO) dry trigger input from an Access Control System, Card Reader, Keypad, Push Button, PIR, etc.
  • Page 3: Installation Instructions

    3. Output options (Fig. 1, pg. 4): The ACM8E provide either eight (8) switched power outputs, eight (8) dry form “C” outputs, or any combination of both switched power and form “C” outputs, plus eight (8) unswitched auxiliary power outputs.
  • Page 4: Typical Application Diagram

    2A 250V 3.5A 250V WARNING: To reduce the risk of fire or electric shock, do not expose LED1 LED1 the unit to rain or moisture. Replace fuses (ACM8E only) with the same type and rating, 3.5A/250V. - 4 - ACM8E/ACM8CBE...
  • Page 5: Led Diagnostics

    (When using AC power supplies polarity need not be observed), NC, C, NO become form “C” 5A/24VAC/VDC rated dry outputs when fuses are removed (ACM8E). Contacts shown in a non-triggered state. FACP INTERFACE Fire Alarm Interface trigger input from FACP. Trigger inputs can be normally open, T, + INPUT –...
  • Page 6: Hookup Diagrams

    Fig. 3 Polarity reversal input from FACP signaling circuit output (polarity is referenced in alarm condition): JUMPER FACP FACP OUTPUT EOL FROM FACP OUTPUT CIRCUIT Fig. 4 Normally Open: Non-Latching FACP trigger input: FACP N.O. TRIGGER INPUT - 6 - ACM8E/ACM8CBE...
  • Page 7 Fig. 6 Normally Closed: Non-Latching FACP trigger input: FACP N.C. DRY TRIGGER INPUT JUMPER Fig. 7 Normally Closed: Latching FACP trigger input with reset: (This output has not been evaluated by UL) FACP N.C. RESET SWITCH N.C. TRIGGER JUMPER INPUT ACM8E/ACM8CBE - 7 -...
  • Page 8: Enclosure Dimensions

    (117.22mm) (38.1mm) Altronix is not responsible for any typographical errors. 140 58th Street, Brooklyn, New York 11220 USA | phone: 718-567-8181 | fax: 718-567-9056 website: www.altronix.com | e-mail: info@altronix.com | Lifetime Warranty | Made in U.S.A. MEMBER IIACM8E/ACM8CBE B22R - 8 -...

This manual is also suitable for:

Acm8cbeAcm8e series

Table of Contents