Rf Diagnostic Menu > [2] Rf Repeater Menu; Diags Menu; Wireless - Bosch B6512 Installation Manual

Control Panels
1.
2.
3.
4.
5.
Point Signal
1.
2.
3.
4.
5.
20.2.8 [3] RF Diagnostic Menu > [2] RF Repeater Menu
You can obtain certain wireless point diagnostic information using a keypad and this menu.
Repeater State
1.
2.
3.
4.
5.
Repeater Signal
1.
2.
3.
4.
5.
20.3

[3] Diags menu

Use the Diagnostics menu to view available diagnostics.
20.3.1

[1] Wireless

The Wireless diagnostics are presented in two different menus for your convenience. Refer to
[3] RF Diagnostic Menu > [1] RF Points, page 120 and [3] RF Diagnostic Menu > [2] RF Repeater
Menu, page 121.
Bosch Security Systems, Inc.
Enter the installer passcode, and then open the [1] Installer Menu.
Go to [2] Wireless > [3] RF Diagnostic Menu > [1] RF Point Diagnostic > [1] Point State.
Use /Previous or /Next to scroll through the list, and go to the point for which you
want to view diagnostic information, or enter the point number.
Press Enter to view the state. The menu scrolls through the following sub-categories,
with the results of the diagnostic check: State, Tamper, Low-Battery, Maintenance.
When finished viewing the information, escape from the menu.
Enter the installer passcode, and then open the [1] Installer Menu.
Go to [2] Wireless > [3] RF Diagnostic Menu > [1] RF Point Diagnostic > [2] Point
Signal.
Use /Previous or /Next to scroll through the list, and go to the point for which you
want to view diagnostic information, or enter the point number.
Press Enter to view the signal strength. The menu scrolls through the following sub-
categories, with the results of the diagnostic check: Signal Strengths, Level, Margin.
When finished viewing the information, escape from the menu.
Enter the installer passcode, and then open the [1] Installer Menu.
Go to [2] Wireless > [3] RF Diagnostic Menu > [2] RF Repeater Menu > [1] Repeater
State.
Use /Previous or /Next to scroll through the list, and go to the repeater for which
you want to view diagnostic information, or enter the repeater number.
Press Enter to view the state. The menu scrolls through the following sub-categories,
with the results of the diagnostic check: State, Missing, Tamper, Low-Battery.
When finished viewing the information, escape from the menu.
Enter the installer passcode, and then open the [1] Installer Menu.
Go to [2] Wireless > [3] RF Diagnostic Menu > [2] RF Repeater Menu > [1] Repeater
Signal.
Use /Previous or /Next to scroll through the list, and go to the repeater for which
you want to view diagnostic information, or enter the repeater number.
Press Enter to view the signal strength. The menu scrolls through the following sub-
categories, with the results of the diagnostic check: Signal Strengths, Level, Margin.
When finished viewing the information, escape from the menu.
Installation Manual
Keypad Installer menu | en 121
2017.04 | 15 | F.01U.287.180