Control Panels
Access Point Name
1.
2.
3.
4.
5.
Access Pt Username
1.
2.
3.
4.
5.
Access Pt Passcode
1.
2.
3.
4.
5.
SIM PIN
1.
2.
3.
4.
5.
20.1.9
[3] RPS > [1] RPS Passcode menu parameters
The control panel verifies the remote programming software at the central station has valid
access before connecting using the RPS passcode. In this menu, you can program the RPS
passcode.
RPS Passcode
1.
2.
3.
4.
5.
6.
Bosch Security Systems, Inc.
Enter the installer passcode, and then open the [1] Installer Menu.
Go to [1] Programming Menu > [2] Network > [2] Cellular > (choose the SDI2 cellular
module or plug-in module) > [1] Access Point Name. The keypad shows the current
configuration.
Press Edit or Enter to edit the configuration.
Delete existing characters, if necessary, and then enter the new characters.
Press Save or Enter. The keypad shows Parameter saved.
Enter the installer passcode, and then open the [1] Installer Menu.
Go to [1] Programming Menu > [2] Network > [2] Cellular > (choose the SDI2 cellular
module or plug-in module) > [2] Access Pt Username. The keypad shows the current
configuration.
Press Edit or Enter to edit the configuration.
Delete existing characters, if necessary, and then enter the new characters.
Press Save or Enter. The keypad shows Parameter saved.
Enter the installer passcode, and then open the [1] Installer Menu.
Go to [1] Programming Menu > [2] Network > [2] Cellular > (choose the SDI2 cellular
module or plug-in module) > [3] Access Pt Password. The keypad shows the current
configuration.
Press Edit or Enter to edit the configuration.
Delete existing characters, if necessary, and then enter the new characters.
Press Save or Enter. The keypad shows Parameter saved.
Enter the installer passcode, and then open the [1] Installer Menu.
Go to [1] Programming Menu > [2] Network > [2] Cellular > (choose the SDI2 cellular
module or plug-in module) > [4] SIM PIN. The keypad shows the current configuration.
Press Edit or Enter to edit the configuration.
Delete existing characters, if necessary, and then enter the new characters.
Press Save or Enter. The keypad shows Parameter saved.
Enter the installer passcode, and then open the [1] Installer Menu.
Go to [1] Programming Menu > [3] RPS > [1] RPS Passcode.
Press Edit or Enter to edit the RPS passcode.
Delete the existing number, if necessary, and enter the new number.
Press Save or Enter. The keypad shows Parameter saved.
Escape from the menu.
Installation Manual
Keypad Installer menu | en 107
2017.04 | 15 | F.01U.287.180