Add/Delete Rf Device (Wireless Zones); Add/Delete Rf Repeater; Add/Delete Rf Keyfob - Bosch ICP-SOL2-P Quick Reference Manual

Control Panel
Notice!
Below commands examples are operated via ICON LCD codepad IUI-SOL-ICON .
3.1

Add/Delete RF Device (Wireless Zones)

Add RF Device
Set RF receiver as RADION Receiver.
1.
2.
3.
4.
RF zone/device ID numbers and RF zone option, refer to RF Zone/Device ID Numbers and RF
Zone Option, page 38.
Delete RF Device
1.
2.
3.
3.2

Add/Delete RF Repeater

Add RF Repeater
Set RF receiver as RADION Receiver.
1.
2.
3.
4.
Delete RF Repeater
1.
2.
3.
3.3

Add/Delete RF Keyfob

Add WE800EV2 Keyfob
Set RF receiver as WE800EV2 Receiver.
1.
2.
Bosch Security Systems, Inc.
Enter the Installer Code, followed by [0] and the [#] key (for example, [12340#]).
Enter the Device Number (1 to 16) you want to add, followed by the [#] key.
Use manual mode or auto-learn mode to configure device RFID.
– In manual mode, enter the 9-digit RF device ID number, followed by the [#] key.
– Or press [#] key to switch into auto-learn mode. When icon numbers (1 to 16) flash,
generate the RF device. The panel learns the RF device ID number and the last digit
of RFID number displays on the codepad. Press [#] key to confirm.
Enter RF zone option (0 to 15), followed by the [#] key. Or Enter [#] key directly.
Enter the Installer Code, followed by [0] and the [#] key.
Enter the Device Number (1 to 16) you want to delete, followed by the [#] key.
Press the [*] key to delete the RF device.
Enter the Installer Code, followed by [0] and the [#] key (for example, [12340#]).
Enter the point id of RADION Repeater (822 to 829) you want to add, followed by the [#]
key. Repeater number (1 to 8 ) displays on the ICON codepad.
Use manual mode or auto-learn mode to configure Repeater RFID.
– In manual mode, enter the 9-digit RF Repeater ID number, followed by the [#] key.
– Or press [#] key to switch into auto-learn mode. When icon numbers (1 to 16) flash,
generate the RF Repeater. The panel learns the RF Repeater ID number and the last
digit of RFID number displays on the codepad. Press [#] key to confirm.
Enter [#] key to confirm the operation, or enter [*] to cancel.
Enter the Installer Code, followed by [0] and the [#] key.
Enter the point id of RADION Repeater (822 to 829) you want to delete, followed by the
[#] key.
Press the [*] key to delete the RF Repeater.
Enter the Master Code, followed by [1] and the [#] key (for example, [12341#]).
Enter the WE800EV2 keyfob number (301 to 321) you want to add, followed by the [#]
key. Only current keyfob number (1 to 16 ) displays on the ICON codepad.
Quick Reference Guide
Operating Commands | en
2014.06 | 02 | F01U298027
13