Wireless Menu; Rf Point Menu> [1] Enroll Point Rfid; Rf Point Menu> [2] Replace Point Rfid; Rf Point Menu> [3] Remove Point Rfid - Bosch B6512 Installation Manual

Control Panels
4.
5.
20.2

[2] Wireless menu

Use the Wireless menu to add, replace, remove, and diagnose points and repeaters.
20.2.1 [1] RF Point Menu> [1] Enroll Point RFID
Once the control panel has points programmed as Wireless, you can enroll RF devices into the
system as a specified wireless points. In this menu, you can enroll RFID points.
Enroll point RFID
1.
2.
3.
4.
5.
6.
7.
20.2.2 [1] RF Point Menu> [2] Replace Point RFID
In this menu, you can replace RFID points.
Replace Point RFID
1.
2.
3.
4.
5.
6.
7.
20.2.3 [1] RF Point Menu> [3] Remove Point RFID
In this menu, you can remove RFID points.
Remove Point RFID
1.
2.
Bosch Security Systems, Inc.
Press Enter and then press Next to view the No option.
Press Save or Enter. The keypad shows Parameter saved.
Escape from the menu.
Enter the installer passcode, and then open the [1] Installer Menu.
Go to [2] Wireless > [1] RF Point Menu > [1] Enroll point RFID. The keypad lists any
enrolled points.
Use /Previous or /Next to scroll through the list of wireless points, and go to the
point for which you want to enroll a device, or simply enter the point number.
Press Yes or Enter to add the device. The keypad instructs you to reset the device.
Initiate activity for the desired RADION device (walk through the coverage pattern if
enrolling a motion detector, or press the button on the keyfob if enrolling a keyfob, or
open the door or window if enrolling a door/window contact), or press the RESET button
on an Inovonics device.
When the keypad indicates that the point enrolled, escape from the menu.
Verify the RFID shown on the keypad matches the RFID label on the activated device.
Enter the installer passcode, and then open the [1] Installer Menu.
Go to [2] Wireless > [1] RF Point Menu > [2] Replace Point RFID. The keypad lists any
enrolled points.
Use /Previous or /Next to scroll through the list of wireless points, and go to the
point for which you want to replace the device, or simply enter the point number.
Press Enter to replace the device. The keypad instructs you to reset the device.
Initiate activity for the desired RADION device (walk through the coverage pattern if
enrolling a motion detector, or press the button on the keyfob if enrolling a keyfob, or
open the door or window if enrolling a door/window contact), or press the RESET button
on an Inovonics device.
When the keypad indicates that the point was replaced, escape from the menu.
Verify the RFID shown on the keypad matches the RFID label on the activated device.
Enter the installer passcode, and then open the [1] Installer Menu.
Go to [2] Wireless > [1] RF Point Menu > [3] Remove Point RFID. The keypad lists any
enrolled points.
Installation Manual
Keypad Installer menu | en 119
2017.04 | 15 | F.01U.287.180